Guangzhou · 3-axis machining
Guangzhou G-VMC650
Guangzhou Machine Tool lists G-VMC650 on the original shared G-VMC650/850/1160 page. The source image itself is marked G-VMC650. Its 750 × 450 mm table and 500 kg loading reference describe a smaller fixture route than the company's gantry machines. Include the base plate, clamps, loaded blanks and centre of gravity in the setup; table area and allowable mass alone do not establish access to every cutting feature.
The 650 column gives X/Y/Z travel 600/450/480 mm, spindle-nose-to-table range 150–630 mm and spindle-centre-to-guide reference 500 mm. Check each datum and retract position with the actual tool and holder projection. A tall fixture can consume the nose window, while a deep pocket can need a longer holder that alters stiffness and collision clearance. The table lists 18 mm T-slot width and 135 mm slot spacing; obtain the actual slot drawing before making a fixture.
The merged original table specifies BT50 and a maximum spindle reference of 8000 rpm across the three models. Its guideway alternatives must remain separate: the prose describes rectangular sliding ways, while the table gives linear-guide and hard-guide speed rows. Ask which delivered build is quoted before using a rapid or cutting-feed value. The source does not identify a complete motor-duty, tool-magazine or controller package for this model; define these in the technical offer.
Catalog specifications
- Table / loading reference
- 750 × 450 mm / 500 kg
- X / Y / Z travel
- 600 / 450 / 480 mm
- Spindle-nose-to-table window
- 150–630 mm
- Spindle-centre-to-guide reference
- 500 mm
- Spindle interface
- BT50; shared original table row
- Maximum spindle reference
- 8000 rpm; shared original table row
The listed outer dimensions are 2.2 × 2.2 × 2.2 m and net mass 5000 kg. Obtain the selected configuration's lifting, foundation, services and maintenance-clearance drawings. For acceptance, trial the intended material, allowance and fixture, record complete elapsed time and inspect the released part. Source-listed positioning values concern an axis test and do not guarantee a finished pocket, bore or clamped-part datum relationship.