Tiantian HTD-T1-4020
Laser · Nanjing Tiantian Machine Tool Manufacturing Co., Ltd.
| Listed sheet working area (mm) | 4000 × 2000 |
|---|---|
| X / Y / Z travel (mm) | 2010 / 4010 / 150 |
The shared HTD-T1 table identifies the 4020 format as 4000 × 2000 mm working area with X/Y/Z travel of 2010/4010/150 mm. It is a sheet-laser format, despite a mistranslated pipe-diameter heading in the source. Check the wider sheet and actual nest against supports, margins, access and handling equipment rather than selecting from the model code alone.
A 4 × 2 m layout needs a defined grip/lift route, alignment and finished-part/remnant removal. Specify sheet mass and flatness, difficult small or thin features and the downstream process. The current table does not reliably establish supported sheet load or operating speed because those rows have mismatched units. Its very broad laser-power range is also not approved as a confirmed 4020 package.
Request one corrected build/revision schedule naming source, head, control, supplied power, chiller, gas and extraction, plus a full occupied layout. Qualify material-specific recipe and released-part geometry/edge finish, and measure complete batch time including loading, piercing, sorting and normal interventions. Current exact-series photos contain factory contact watermarks and are not republished as model-matched imagery. Obtain an exact build photograph and verify seller, builder, commissioning and destination service scope in writing.
| Same listing |
|---|
| HTD-T1-3015 |
| HTD-T1-6025 |