Amada · Laser
Amada VENTIS-3015AJ
VENTIS-3015AJ is the 4 kW fibre-laser reference on AMADA’s China model page. LBC, Locus Beam Control, controls the beam’s trajectory according to material and thickness. The published processing envelope is 3070 / 1550 / 100 mm in X / Y / Z. This page does not combine its power rating with the separate higher-power ENSIS editions.
The page lists maximum thickness references of 16 mm mild steel, 10 mm stainless and 8 mm aluminium. Treat these as catalogue boundaries, not a promise of the same edge quality, minimum hole geometry or finished-sheet rate at every grade and thickness. Send a representative nest with edge, burr/dross, flatness and downstream welding/coating requirements; agree assist gas and acceptance measurements.
The reviewed page describes an eight-position automatic nozzle changer and AMNC 3i control. Loading and other automation upgrades require a defined project scope. Trial piercing, nozzle changes, small-part stability, scrap, material change and loading alongside cutting. Record accepted output and actual gas/consumables, rather than transferring advertised comparisons against other laser powers to the buyer’s part.
Catalog specifications
- Rated fibre-laser power
- 4000 W
- Beam technology
- LBC — Locus Beam Control
- Maximum processing envelope X / Y / Z
- 3070 / 1550 / 100 mm
- Axis movement speed X / Y / Z
- 120 / 120 / 80 m/min
- Page maximum thickness references
- Mild steel 16 mm / stainless 10 mm / aluminium 8 mm; verify grade and required cut quality
- Nozzle changer on reviewed page
- 8 positions, automatic