Waji CK5116F

Waji’s CK5116F×12/5 specification is the particular reference behind this existing CK5116F page. It lists Ø1600 mm maximum cutting diameter, 1250 mm workpiece height, Ø1400 mm table and 5000 kg workpiece mass. Its larger cutting envelope does not automatically solve support of an overhanging ring or offset casting. Submit the actual blank, jaws, fixtures and centre of gravity, and agree the allowed total loading and restraint before committing the table layout.

The sheet gives 1000 mm horizontal and 1000 mm vertical ram travel, 40 × 40 mm tool shank and separately 1000 mm crossrail movement. Confirm the beam position and full holder/tool envelope for the deepest bore, taper, shoulder and retract sequence. The original turret descriptions alternate four and five stations, so no station count is asserted here. Put the selected carrier, occupied-tool map, index sequence and collision drawing on one revision of the technical offer.

The base specification describes a 16-step 5–160 rpm table drive, 30 kW main motor and Siemens 828D X/Z control. A two-range stepless drive is a separate choice; the source makes constant surface speed conditional on that choice. Confirm spindle encoder and thread functions, torque versus speed and actual controller configuration. Do not combine the stepped table with all benefits of an optional drive or transfer the 37 kW motor of the smaller ×12/3 reference.

For a heavy housing or flange, trial representative roughing engagement, interrupted cuts, chip clearing and the critical internal reach using the proposed fixture. Verify drawing datums, roundness, flatness and finish after unclamping, recording the complete loading and accepted-part cycle. The approximate 13,000 kg machine mass is not a foundation calculation. Require installation/lifting drawings and destination service scope. The shared source photograph is CK5112B family material, not a verified CK5116F machine photo; request a matching selected-build image.