Aplus FGV1060

APLOS FGV1060 is the base configuration in the manufacturer’s FGV family table. Its listed X / Y / Z travel is 1000 / 600 / 600 mm, with a 1100 × 600 mm table and 1000 kg rated load. Check blank and fixture together: table load alone does not show whether the cutter can reach a deep pocket or clear a tall clamp.

The family table gives 100–700 mm spindle-nose-to-table distance, 3280 / 2350 / 4100 mm width/depth/height and 14000 kg mass, with Fagor 8060M. These are planning references; obtain the ordered-build foundation, handling and service-clearance drawing before committing the installation area.

This base-model table does not specify a complete spindle speed, motor duty or tool-magazine schedule. The dedicated FGV1060A page provides those details for a separate build; its highest values should not be transferred to FGV1060. Specify material, tool diameter/projection and roughing/finishing operation, then request the exact spindle torque curve and tool schedule.

For a mould or contoured component, trial the production program at its tightest curvature with the intended tool, holder and fixture. Inspect form and surface against the drawing after release; include warm-up, setup, tool changes and rejected parts in the accepted-output comparison. The original family photograph is marked FGV1060 and illustrates the enclosure, without establishing the ordered internal configuration.