Skip to content

Hengda turning

Hengda HL256-T500

Zhejiang Hengda CNC Equipment Co., Ltd. · Shaoxing

  1. Maximum cutting diameter / length480 / 500 mm
  2. Bed swing570 mm
  3. Bar capacity / spindle bore52 / 61 mm
  4. Maximum spindle speed4000 rpm
  5. Spindle nose / chuckA2-6 / 8 inches

Hengda HL256-T500 is the non-S, non-Y T configuration in the 25-series 500 table. Maximum cutting diameter/length is Ø480 / 500 mm, with Ø570 mm bed swing. Define jaws, shoulders, support and the full occupied turret for the larger blank; the family’s bigger swing or milling-category heading does not establish extra cutting access.

The spindle column gives A2-6, an 8-inch hydraulic-chuck reference, Ø61 mm through-hole, Ø52 mm maximum bar and 4000 rpm maximum speed. Main-motor torque is listed as 147 N·m, separate from an installed spindle output/duty curve. Match the actual chuck/tube/liner and feeder to the blank and unsupported length; the HL258 family’s 75 mm bar reference is a different configuration.

X/Z travel is 240 / 525 mm with 30 / 30 m/min rapid movement. Twelve stations accept the listed 25 × 25 mm turning shank or Ø40 mm boring-shank reference. The hydraulic tailstock lists Ø100 mm sleeve, 125 mm sleeve stroke and Morse 5. The T500 column shows no Y travel or sub-spindle; S, Y and Z suffixes have separate support/axis and tool envelopes and must be quoted explicitly if the part needs them.

Run the representative shaft and datum setup with agreed roughing/finishing duty, supports and tool projection, then inspect after unclamping. Include tool changes, chip disposal, loading and rejects in accepted output. The reference is 4800 kg, 3975 × 2140 × 1910 mm and 25 kVA total electrical capacity, subject to ordered auxiliaries. Current family photographs/illustrations do not independently prove this exact T500 build, so configuration and media gaps remain recorded privately.

Additional specifications

X / Z travel
240 / 525 mm
Rapid X / Z
30 / 30 m/min
Turret positions
12
Turning / boring shank
25 × 25 mm / 40 mm diameter
Hydraulic tailstock sleeve diameter / stroke
100 / 125 mm
Tailstock taper
Morse 5
Total electrical capacity reference
25 kVA
Main motor torque reference
147 N·m; spindle output/duty separate
Exterior dimensions reference
3975 × 2140 × 1910 mm
Machine mass
4800 kg

Figures come from the manufacturer's model material. Confirm the selected options in your RFQ.