Kede DMC50

DMC50’s original model table separates machining travel from tool-change allowance: X/Y/Z is written 450 + 75 (tool change) / 600 + 25 (tool change) / 400 (375) mm. The extra X/Y values do not enlarge machining travel. Published nose-to-table distance is 150–550 (150–525) mm; resolve the bracketed build conditions with the supplier. Send the full cradle fixture, clamp and holder assembly for a swept collision/reach review, not just the bare-part bounding box.

The table gives a Ø450 × □370 mm Table 1 with 250 kg capacity, and a distinct Ø370 mm Table 2 rated 250 kg for milling but 150 kg for turning. Table 2’s maximum turning speed is 2000 rpm; agree turning-module, balance, workholding and load conditions rather than treating the milling payload as a turning payload. A/C range is written −130 to +90 degrees/unrestricted, with table-specific speed entries; obtain the selected axis diagram and safe limits.

Choose one spindle package. HFS15020/24 uses HSK-A63 with 20000 rpm grease or 24000 rpm oil-air lubrication, and 20/30 kW at 100/40% DC. The distinct HFS17018-MT milling/turning entry is 18000 rpm grease, HSK-A63, 30 kW at 100% DC and 42/71 Nm at 100/25% DC. Other entries use 15000 rpm HSK-A63/BT40, 30000 rpm HSK-A50 or 40000 rpm HSK-E40. Neither their power nor their holder interfaces should be combined into the same build.

The standard magazine entry is 32 tools, 70 mm tool diameter with neighbours versus 110 mm without neighbours, 250 mm maximum length and 7 kg mass. Map complete tool occupancy and reach. Published linear positioning/repeat references are 5/4 μm, and A/C 5/4 arcseconds; these are not finished-feature guarantees. Trial the quoted CAM post, control functions, fixture and thermal conditions, inspect after release and demonstrate restart. The retained exact-page structural illustration is identified as a manufacturer illustration, not a delivered-machine photograph; table dimensions are 3250 × 2230 × 2780 mm and approximately 7 t.